NEW BRUNSWICK SCIENTIFIC C2 Classic, Manual To Operations

Page: 22 / 41

22
5.2 Installation of Clamps
Flask clamps purchased for use with universal platforms require installation. Clamps are
installed by securing the base of the clamp to the platform with the correct type and
number of screws.
For all platforms used on the C2 shaker, use only the screws listed in the table below:
10 - 500 ml Clamp Hardware Application Chart
Description Part Number Qty. Application
10-24 x 5/16 (7.9 mm)
flat Phillips (+) head
screw S2116-3051 1 5/16 inch (7.9 mm)
thick aluminum,
phenolic and stainless
steel platforms.
5.3 Electrical Connections
Before making electrical connections, verify that the power source voltage matches the
voltage on the
ELECTRICAL SPECIFICATION PLATE
and the
ON/OFF SWITCH
is on the
OFF
position ( see Figure 3 ). The
ELECTRICAL SPECIFICATION PLATE
is located on the
side panel of the unit near the
ON/OFF SWITCH
. Connect the
POWER CORD
to the
POWER CONNECTOR
and the other end to a suitable, grounded receptacle.
Figure 3: C2 Rear Panel
ON/OFF
SWITCH
(on side
panel)
FUSE
HOLDER
POWER
CONNECTOR
M1244-0051
Y
C2 Classic Platform Shaker User’s Guide