88 Outboard Series / 8804 Fader pack
Issue 2.7
Getting Started
Install the Recall software provided on to your PC or Mac and then start it
running.
Please refer to page 11 on how to do this.
Connect the 8804 USB port to a PC (or Mac) using a USB cable.
It should be connected directly to the computer or via a powered USB hub
but
not
via a passive USB hub.
The 8804 has no power supply, and takes it's power from the computer via
USB.
Connect the 50 pin
Fader I/O
socket on the rear of the 8804 to the 50 pin
socket on the rear of the 8816 using the cable provided.
Connect the associated 8816 to the same PC (or Mac) using a USB cable.
If the Recall software has been started, the 8804 fader pack will now control
the level of signals on the 8816 channel inputs and master outputs.
Mutes and Solos may be controlled from either the 8804 or the 8816 Mute /
Solo switches.
The Mute and Solo buttons will not synchronise between the two
units until both units are connected to the PC (or Mac) via USB and
the Recall software is running.
- 5 -
