15
ON/
OFF
MPCX2 Control / Receiver setup procedure
Before using the MPCX2 control it must be mated to the receiver(s) and set for the model of scoreboard that
you wish to operate.
Mating a New Control to Receiver(s)
Step 1.
Record the receiver(s) ID’s located on the receiver box before
installation for future reference. Multiple receivers can be
used with multiple controllers all on the same network.
Step 2.
Install the receiver(s) into the scoreboard and power up the
receiver(s) that are to be used.
a.
Standard Installation – Uses the RJ12 output of the receiver.
b.
Rain Type Box Installation – Uses the coax output of the receiver and a 9VDC power
supply.
Step 3.
Wait approximately 15 seconds after the receiver has been turned on before turning on the
MPCX2 controller in order to allow enough time for the receiver to be initialized.
Step 4.
Insert the batteries included with the MPCX2 control or turn the control ON by pressing
The display will read:
Step 5.
Enter in the receiver ID’s located on the receiver box using the controller keypad buttons
(NEXT) to move the cursor and or to increment or decrement each digit.
When done press the (BACK) button in the lower left corner.
Step 6.
The screen will then prompt with.
Step 7.
Pressing will reset the controller. Pressing will allow additional receiver ID’s to be
entered into the controller and will display the message.
Step 8.
If additional receivers are to be added then select and repeat steps 5 through 6. If
additional receivers do not need to be added then select and the controller will be reset.
Enter Rec ID:
000000
Reset Now?
(+)NOW (-)LATER
Add Another?
(+)YES (-)NO
+
-
+
-
+
-
Options
Record Receiver ID’s Here
