Nevadent NSLP 3.7 A1, Operating Instructions Manual

Page: 11 / 52

NSLP 3.7 A1 ■ 8
│
GB
│
IE
│
NI
│
CY
Use
This toothbrush has 5 different power levels:
–
"White": high speed, for especially thorough cleaning of the teeth; the
"White" LED
lights up
–
"Clean": normal speed, for daily cleaning, "Clean" LED lights up.
–
"Sensitive": slow speed, for people with sensitive teeth and gums, the
"Sensitive" LED
lights up
–
"Polish": highest speed, for polishing teeth, the "Polish" LED lights up
NOTICE ON POLISHING
► To polish the teeth, add a little dental polishing paste to the brush head .
Apply the brush head directly to the tooth. When polishing your teeth,
do
not
start at the gums like during normal brushing.
Move the appliance in a circular motion up and down to polish the tooth.
Polish each tooth for approx. 20–30 seconds.
► It is normally sufficient to polish your teeth twice a week.
–
"Pulse": normal speed with short breaks, to massage the gums, the
"Pulse" LED
lights up.
■ Press the On/Off button once to activate the "White" mode. The "White"
LED and the "Accu" LED light up.
■ Press the On/Off button once to switch up through various modes in the
order described. The respective operating LED and the "Accu" LED light
up.
■ Press the On/Off button again while the toothbrush is in "Pulse" mode to
switch off the toothbrush.
NOTE
If you operate one of the modes for longer than 10 seconds and then
press the On/Off button
, the toothbrush will switch off.
Next time you switch it on, the toothbrush will automatically start in
the mode you were using last.
To change the mode again, press the On/Off button repeatedly
until the appliance switches to the required mode as described above.