Nevadent NSLP 3.7 A1, Operating Instructions Manual

Page: 10 / 52

NSLP 3.7 A1 GB
│
IE
│
NI
│
CY
│ 7 ■
First use
NOTE
Before starting to use the appliance, check that it is in fault-free condi-
tion. If not, it must not be used.
1) Insert the plug of the charger into a mains power socket.
2) Before first use, clean the new brush heads with fresh water.
3) Put the replacement brush heads into the replacement brush head holders
3
.
Then put the lid
!
on.
4) Place the handset on the charger so that it slides onto the pin on the
base.
5) Allow the handset to charge for around 18 hours before using it for the first
time. The "Accu" LED on the front of the handset lights up orange when the
battery is under 50% charge capacity and green at more than 50% capacity
during the charging process. Once the charging process is complete, the
"Accu" LED
lights up green permanently.
6) Use the handset repeatedly without recharging the battery until the tooth-
brush pulses three times or stops working and the "Accu" LED flashes
red. Then, recharge the battery for 18 hours. Once the appliance is fully
charged, the "Accu" LED
lights up green permanently.
7) Completely charge and discharge the toothbrush 3 times. The battery will
have then reached its full capacity.
8) You can now leave the handset in the charger after every use, so as to
always have full power available.
Fitting/removing brush heads
■ To remove the brush head , pull it upwards and off the drive shaft .
■ When fitting the brush head , ensure that the drive shaft on the handset
slides precisely into the socket on the brush head .
Push the brush head down until it completely covers the drive shaft .