11
User Manual – Gigabit PoE Supply NPS-30W | BDA 579 V2 2020/06
Operation
5 Operation
5.1 Preparations
T
Unpacking the Gigabit PoE Supply.
T
Save packaging for later transport and storage.
T
Check the packaging and the Gigabit PoE Supply for visible damage.
T
When visible damage to the packaging and/or delivered parts is detected:
Contact the salesperson or Neutrik sales partner.
T
Do not use damaged devices under any circumstances.
5.2 Connecting devices with the Gigabit PoE Supply
The Gigabit PoE Supply is installed as a midspan device between the PoE powered device and a
Ethernet device without power output.
•
For a load of 20 W or higher, it is mandatory to use AWG24 or higher cross-section
cables.
•
For cable lengths of 50 m or longer, it is mandatory to use AWG24 or higher cross-
section cables.
•
F / UTP Kat 6A cables are recommended.
(F / UTP cables can better dissipate heat due to the screen)
w
NOTE
Risk of device damage!
T
Do not combine NPS-30W Gigabit PoE Supply with other PoE Supplies, as this can cause a
damage to the powered device due to different pin assignment.
T
When using 2 NPS-30W PoE Supplies, do not use cables with different connection standards
(TIA568A vs TIA568B). Never use Ethernet Cross-cables within PoE connections.
T
Connect the devices depending on the desired application.
T
Connect the Gigabit PoE Supply with the power supply.
LEDs light up once the Gigabit PoE Supply is supplied with power.
The Gigabit PoE Supply is ready for operation.