Neutral X-DREi, Owner'S Manual

Page: 9 / 20

X-
DREI
<8>
•
If you have active speakers directly connect the X-DREI at the input to the internal
amplifier.
•
For bi-amping your speakers connect the RCA to the amplifier of middles and trebles
and the XLR (balanced) to the bass amplifier. Note that this product is not a filter and
the entire musical signal is on both outputs. You may need to adjust the internal gain
of the amplifiers.
•
To connect a second system in another room use the RCA for the nearest amplifier
and Balanced (XLR) to the farthest.
• For a duplex system in mono, connect only one input to the corresponding left
channel and use any of the four outputs in the desired configuration. Repeat with
another X-DREI on the other channel. The advantages of this configuration are
obvious when looking for the complete separation of channels, including separate
preamps as in the case of model X-QUANTUM Neutral Audio. Do not forget to
change the internal switch to
“mono”.
• The output is muted when you connect headphones.
DUPLEX/MONOPHONIC MODE
To set this up in mono reposition
the internal switch found inside the
HighEnd
Model
or the outside
MONO switch on the PRO model.
Only can connect the Left input.
Before opening the lid
DISCONNECT the device from the
energy supply to keep you safe
from injury
.