NEULOG ELECTROCARDIOGRAM LOGGER SENSOR GUIDE
Quick start procedure:
PC or Mac Computer
Materials needed:
NUL-218 ECG Sensor
3 Neulog Reusable Clamp Leads
USB-200 USB Module
USB to mini USB cable (included with the USB-200 module)
Your ECG sensor needs to be connected to a USB-200 module. The USB-
200 module then connects to a computer via a USB to mini-USB cable.
Please note that you cannot plug the ECG sensor directly into the computer.
Resident PC software and browser based application can be downloaded for
free at
www.neulog.com/Download/SoftwareandApplication.aspx
as well as a full
software user guide.
Note:
Make sure not to download and install both types of software they
will conflict on the computer.
Procedure:
1.
Install the NeuLog software
2.
Connect the USB-200 module to the PC or Mac
3.
Connect the ECG sensor to the USB-200 module (they directly plug
together). Please note there is no calibration required for this sensor.
4.
Open the NeuLog software.
5.
Once an ECG sensor logo appears on the left side of the screen the
probe has been automatically identified and you can begin
experimentation.
6.
If the ECG sensor is not automatically identified then click the “Search
for sensors” icon to find the sensor.
7.
Select the “On-line experiment” button; this will open a graph below.
8.
Click on the “Module setup” button located on the ECG sensor icon in
the module window to change the sensor settings if need be.
9.
Click on the "experiment set up" button to change the experiment
settings if need be (experiment duration for example).
10.
The ECG sensor will give a live reading in the box to the left of the
screen while plugged in.
11.
To run an experiment and collect data click “Run experiment”.
12.
To end data collection early, click “Stop experiment”.
Tablet, smart phone device
Materials needed:
NUL-218 ECG Sensor
3 Neulog Reusable Clamp Leads
WIFI-201 WIFI module
BAT-200 Battery
Your ECG sensor needs to be connected to a WIFI-201 module. The WIFI-
201 module will create a closed NeuLog WiFi network which will stream
the NeuLog data to a device of your choosing. Once your device is
wirelessly connected to the NeuLog network you can run experiments and
collect data through a browser of your choosing.
Procedure:
1.
Connect the ECG sensor directly to the left side WIFI-201 (no wires
required).
2.
Connect a BAT-200 module to the right side of the WIFI-201 module.
3.
Although not required, we recommend plugging the BAT-200 to an
outlet using a USB to mini USB charger (such as a typical cell phone
charger). The WIFI-201 module will run for 15-75 minutes (depending
on the sensor) without being plugged in.