Neue IDSH603W, User Manual

Page: 7 / 16

German degrees
(°dH)
French degrees
(°fH)
mmol/l Clarke de-
grees
Water softener level
43 - 46 76 - 83 7.6 - 8.3 53 - 57 9
37 - 42 65 - 75 6.5 - 7.5 46 - 52 8
29 - 36 51 - 64 5.1 - 6.4 36 - 45 7
23 - 28 40 - 50 4.0 - 5.0 28 - 35 6
19 - 22 33 - 39 3.3 - 3.9 23 - 27
5 1)
15 - 18 26 - 32 2.6 - 3.2 18 - 22 4
11 - 14 19 - 25 1.9 - 2.5 13 - 17 3
4 - 10 7 - 18 0.7 - 1.8 5 - 12 2
<4 <7 <0.7 < 5
1 2)
1) Factory setting.
2) Do not use salt at this level.
If you use multi-tablets containing salt and the hardness
of your water is lower than 21°dH, you can set the
lowest water softener level. It deactivates the salt refill
indicator.
If you use standard detergent or multi-tablets
without salt, set the proper water hardness level to
keep the salt refill indicator active.
How to set the water softener level
The appliance must be in programme selection mode.
1. To enter the user mode, press and hold the
programme button until the indicator starts
to flash and the indicator comes on with fixed
light.
2. Wait until the indicator goes off and the
indicator starts to flash. The indicator
continues to flash. The intermittent flashing of the
indicator
refers to the current set level.
• E.g. 5 f pause + 5 flashes = level5.
3. Press programme button repeatedly to change the
setting. Each time you press programme button the
level number increases. After level 10 you will start
again from level 1.
4. Press the on/off button to confirm the setting.
Acoustic signals
Acoustic signals sound when a malfunction of the
appliance occurs. It is not possible to deactivate these
acoustic signals.
There is also an acoustic signal that sounds when the
programme is completed. By default this acoustic signal
is deactivated but it is possible to activate it.
How to activate the acoustic signal for the end of
programme
The appliance must be in programme selection mode.
1. To enter the user mode, press and hold the
programme button until the indicator starts
to flash and the indicator comes on with fixed
light.
2. Press immediately the programme button.
• The indicator comes on with fixed light.
• The indicator starts to flash.
3. Wait until the indicator goes off. The
indicator continues to flash.
• The end indicator indicates the current setting:
End indicator off = Acoustic signal off.
4. Press the programme button to change the setting.
• End indicator on = Acoustic signal on.
5. Press the on/off button confirm the setting.
7