6
g) Use the power tool, accessories and tool bits etc., in
accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions and
the work to be performed. Use of the power tool for
operations different from those intended could result in
a hazardous situation.
5) SERVICE
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
SAFETY INSTRUCTIONS FOR TACKERS
• Secure the workpiece (a workpiece clamped with
clamping devices or in a vice is held more securely than
by hand)
• Never push in the tacker head manually
4
(there is
danger of injury when at the same time the trigger
is activated unintentionally)
• Never use the tool for fastening electrical wiring
(contact with electrical wires can lead to fi re and electric
shock)
• Avoid damage that can be caused by screws, nails and
other elements in your workpiece; remove them before
you start working
• Always check that the supply voltage is the same as the
voltage indicated on the nameplate of the tacker
(tackers with a rating of 230V or 240V can also be
connected to a 220V supply)
• In case of electrical or mechanical malfunction,
immediately switch off the tool or unplug charger from
power source
• We can assure
flawless functioning of the tool only
when original accessories are used
• This tool should not be used by people under the age of
16 years
USE
• Loading staples/nails
6
- turn tool upside down
- press lever A while pulling slider B backwards
- insert the staple/nail strip into magazine C with legs
facing upward (maximal capacity 100 staples)
- push slider B against tacker head D until it snap-
locks
- when inserting a nail strip (not supplied with the tool)
tilt the tool in such a way, that the nail strip rests
against the magazine side which corresponds with
the nail symbol on tacker head D
7
• Operating the tool
8
- fi rmly press tacker head D against the workpiece until
it is pushed in a few millimeters
- briefl y press switch E and then release again
- switch F is locked as long as you do not press tacker
head E against the workpiece,
thus preventing accidental operation
! remove all staples/nails from the magazine after
each use
• Impact control
9
With wheel G the required impact level can be selected
in steps
- indicator F shows the selected impact level
- “-” for thin and light materials such as foils and
fabrics
- “+” for thick and tough materials such as hard
woods and walls
- before starting a job, fi nd the optimal impact level by
testing out on spare material
IB2100db.indd 7
06-06-2006 15:03:45
APPLICATION ADVICE
• Fastening panels
0
• Do not use the tool for fastening ceiling panelling on
profi led wood or grooves
• Fixing textiles
!
• Avoid blank shots in order to reduce the wear of the
impact strike
• Do not expose tool to rain.
5
- At 20 shots/min,tacker should be allowed to cool down
after 30 minutes as it is only rated for short-time duty.
Summary of Contents for N6013
Page 3: ...3 7 8 6 A D 1 2 3 C B...
Page 4: ...4 0 9 G...
