10
CHANGING USER CODES
Step 1
Your system must be in the Disarmed state to change user codes.
Step 2
Press [
r
]-[5].
Step 3
Enter a “Master Arm/Disarm Code”.
NOTE: For partitioned systems, someone changing the code of
another person must have access to all or more partitions than
the user being changed.
Step 4
The ready light will flash.
Step 5
Enter the 2-digit “user number”. You must always enter 2 digits,
such as [0] - [3] for user 3, or [5] - [2] for user 52.
Step 6
Enter the new four (4) or six (6) digit “user code”.
NOTE: To delete a user code, enter [
r
]-[
r
]-[
r
]-[
r
] for a 4-digit code,
or [
r
]-[
r
]-[
r
]-[
r
]-[
r
]-[
r
] for a 6-digit code.
Step 7
The ready light will flash indicating you are back at Step 4 above. If
the code is rejected, the sounder will beep 3 times.
Step 8
If another “user code” needs to be programmed, return to Step 5.
Step 9
Press the [#] key while the ready light is flashing to exit the User
Code Programming Mode.
ASSIGNING USER CODE AUTHORITY LEVELS
Assign authority levels to users by following the steps below. Assign user codes
before assigning authority levels.
Step 1
Press [
r
]-[6].
Step 2
Enter a “Master Arm/Disarm Code”.
NOTE: Someone changing the authority of another person can
only add or remove partition authorization for partitions to
which they have access.
Step 3
The ready light will flash.
Step 4
Enter the 2-digit “user number” to be assigned authority (The ready
light is constant and the instant light will flash).
Step 5
Lights illuminated indicate the authority levels assigned to this code.
An explanation of the lights is listed below. You may toggle (turn
on/off) the authority level by pressing the number for that authority
level.
