Installing a Redundant Power Supply Module
The
Micro 100-TX24
repeater comes with a pre-installed, 90-watt power supply module (
PWR A
). You can install an
optional redundant power supply module (
PWR B
) for backup power. Contact your NetWorth reseller for information
about ordering an additional power supply module.
Follow these steps to install a redundant power supply module.
Note: You can install the redundant power supply module while the main power supply module is
powered on.
1.
Remove the two screws from the
PWR B
cover plate and remove the plate. Be sure you keep the cover plate and
screws in case you need them for future use.
2.
Carefully insert the power supply module into the opening until its 10-pin connector engages with the internal
power connector and the face of the module is flush with the repeaters back panel.
3.
Secure the power supply by tightening its two spring screws.
4.
Plug the female IEC power cable connector into the connector on the new power supply module.
5.
Insert the power cables three-pronged plug into a non-switched, grounded power source (e.g., wall outlet, power
strip, or grounded extension cord).
When you connect power, the
PWR B
LED indicator lights green to indicate that the power supply module is
installed and functioning correctly.
Note: If the power supply module does not have power or is not functioning correctly, the
PWR B
LED indicator lights yellow.
PWR B
PWR A
Spring Screws
Redundant Power Supply Module
Figure 3-7: Installing a Redundant Power Module
Installing a Redundant Power Supply Module
Installing the Repeater
3 - 6
