NTI VEEMUX VIDEO MATRIX SWITCH
20
To save a configuraton
, from the
Stored Configurations
user interface, use the drop-down list to select the
desired slot (numbers 0-99) to save the active configuration into and press the
Save
button.
Note: This will save the currently active configuration on
the VEEMUX. If changes have been made in the web
interface without first pressing the Submit button, those
changes will not yet be part of the active configuration.
Note: If changes to the active configuration have been
made by another user prior to saving the current
connection selections, the changes made by the other
user will be saved as the configuration.
The webpage configuration that loads after a
Save
is the
configuration that was actually saved.
To load a saved configuration
, from the
Stored Configurations
user interface, use the drop-down list to select the
desired configuration. Then press the
Load
button. The VEEMUX will make the connections and the screen will
refresh to show the connections associated with that configuration selection.
FYI: Configurations saved via the keypad (pg. 7) can be recalled through this interface, and vice versa. They are one in
the same.
Setup Pages
These settings enable the user to configure the VEEMUX web interface connection. This change will take a few
seconds and automatically redirect the user to the IP address specified.
Note: Since the webserver will be restarting all active connections will be logged out.
The Website Timeout option controls how long an inactive web connection will stay logged in.
Any change to the Website Timeout configuration takes effect immediately.
The “Telnet configuration” block enables the VEEMUX to receive commands on port 2005 in addition to port 2000.
For more on telnet use, see “Telnet Interface- Port 2000” on page 13.
Figure 10- Web interface Setup page
