2
To mount multiple E-ACDCLM
in close proximity to the E-16D, install an extension rail kit (NTI E-RL-16D - sold separately) and
mount E-ACDCLM as seen in the illustration below.
CONNECTION
Note: To prevent damage to the voltage source or the Sensor Adapter proper polarity must be observed when making
connections.
1.
At the “AC VOLTAGE” terminal block, connect an AC voltage source to be monitored between 0 and 240VAC.
Note: The AC connection does not require any specific polarity.
2. At the “DC VOLTAGE” terminal block, connect a -60 to +60VDC voltage source to be monitored to the “Vin“ and “
“
(
earth
ground
)
connections using the removable terminal block.
3. If current sensing is desired, install a hall effect sensor to the AC or DC circuit to be monitored. Then connect the supplied
4-wire cable to the sensor. Connect the 4 wires at the end of the cable to the AC or DC CURRENT TRANSDUCER
(depending upon the type of circuit being sensed) terminals on the E-ACDCLM.
Note: If a hall-effect sensor is installed on a DC circuit and then the sensing cable is connected to the “AC CURRENT
TRANSDUCER” side of the E-ACDCLM, no reading will be displayed for that sensor.
Note: The wire connection terminal block is easily removed from the Sensor Adapter for convenient wire termination.
