WOS-2x1 / WOS-2x2
Rev. 6
Network Electronics ASA, Thorøya, 3204 Sandefjord, Norway, Tel.:+47 33 48 99 99 Fax: +47 33 48 99 98
E-mail: [email protected] - Web: http://www.network-electronics.com
Technical specifications are subject to be changed without notice
4
1. General
Figure 1: Block diagram of the WOS-2x1 and
WOS-2x1L operation. Main position.
Figure 2: Block diagram of the WOS-2x2 and
WOS-2x2L operation. Standby position,
The
flashlink
®
2 x 1 Wideband Optical Switch and 2x2 Wideband Optical Switch are fiber optical SPDT
(Single Pole Double Throw) changeover modules for use together with the WOS-C1 connector module.
Typical applications for these units are selective routing of optical signal paths without optical-to-
electrical conversion and Automatic Protection Switching (APS). The units are controlled via the
flashlink
®
GYDA control system or the GPI interface.
The optical switches operate in the 2
nd
and 3
rd
optical windows (1310nm and 1550nm)
The WOS-2x1 has two input/output ports and one common port.
The WOS-2x2 has two input ports and two output ports.
The product is available in four different versions all delivered with WOS-C1 connector module:
WOS-2x1
2x1 Wideband Optical Switch, non-latching trigger type
For selective routing
WOS-2x2
2x2 Wideband Optical Switch, non-latching trigger type
For selective routing
WOS-2x1L 2x1 Wideband Optical Switch, latching trigger type
For APS
WOS-2x2L 2x2 Wideband Optical Switch, latching trigger type
For APS
