netvox Z311C, User Manual

Page: 9 / 14

9
5.7. HeartBeat Technique
In a security system, it is important that Zone devices report the conditions to the central security unit (the
CIE device). To meet this need, Netvox came up with a technique called “
HeartBeat ”.
Right after Z311C enrolls to a security system, it sends a HeartBeat signal to the CIE device. Afterward, it will
send HeartBeat data every hour by default settings.
5.8. Battery
Low-power report: The working voltage for Z311C is 2.1~3.6V. When the operating voltage is lower than
2.1V, Z311C will send a low-power report to the CIE device.
The related data:
 Power configuration cluster (ID:0x0001)
 Battery voltage attribute (ID:0x0020)
5.9. Restore to Factory Setting
While Z311C is unable to communicate with its enrolled CIE device or users would like Z311C to join a new
network, a factory reset is required. To restore it to factory setting, please follow the steps:
Step1. Press and hold both the Auxiliary Key and the Binding Key .
Step2. The indicator will flash red twice. Keep pressing and holding the both buttons.
Step3. Until the indicator starts flashing red again, release both buttons.
Step4. After 10 red flashes, it will go into turn-off mode.
After the factory restore, please refer to Chapter 5.1. Turn On/ Turn Off Z311C to setup it.