6
5. Data Report
Data report configuration and sending period are as following:
Min Interval
(Unit: second)
Max Interval
(Unit: second)
Reportable Change
Current Change
≥
Reportable Change
Current Change
＜
Reportable Change
Any number between
1~65535
Any number between
1~65535
Can not be 0.
Report
per Min Interval
Report
per Max Interval
The device will immediately send a version packet report along with an uplink packet including status,distance, temperature,
angle of tilt, fill level of percentage.
The device sends data in the default configuration before any configuration is done.
Default Setting:
MaxTime: Max Interval = 15 min = 900s
MinTime: Max Interval = 15 min = 900s
BatteryChange = 0x01 (0.1v)
DistanceChange = 0x012C (300mm)
TemperatureChange = 0x0A (1°C)
OnDistanceThreshold = 0x01F4 (500mm)
FillMaxDistance = 0x07D0 (2000mm)
AngleChange = 0x0F
(15°)
*Cannot be modified
Data packet:
a.
When used in waste bin detection:
Distance, Temperature, AngleofInclination, FillLevel;
Status=0 (Invalid)
b.
When used in parking detection:
Status, Distance, Temperature, AngleofInclination;
FillLevel=0 (Invalid)
Note:
(1)
The device report interval will be programmed based on the default firmware which may vary.
(2)
The interval between two reports must be the minimum time.
Please refer Netvox
LoRaWAN Application Command document
and
Netvox Lora Command Resolver
