5
5. Data Report
Data report configuration and sending period are as following:
Min Interval
(Unit:second)
Max Interval
(Unit:second)
Reportable Change
Current Change
≥
Reportable Change
Current Change
＜
Reportable Change
Any number between
1~65535
Any number between
1~65535
Can not be 0.
Report
per Min Interval
Report
per Max Interval
The device will immediately send a version packet report along with an uplink packet including water leak status, temperature,
humidity and battery voltage. The device sends data in the default configuration before any configuration is done.
Default setting:
MaxTime: 3600s (if there is special customized shipment, the setting will change according to the customer's requirements)
MinTime: 3600s (by default, the current voltage value is detected every min interval)
Battery Change: 0x01 (Unit:0.1v, 0.1V)
Temperature Change: 0x64 (Unit:0.01°, 1°C)
Humidity Change: 0x64 (Unit:0.01%, 1%)
Water leak detection:
When R718WAA detects water leakage, it will immediately report a leak status as "1"
When R718WAA does not detect water leakage, it will immediately report a leak status as "0"
Note:
The device report interval will be programmed based on the default firmware which may vary.
The interval between two reports must be the minimum time.
Please refer Netvox
LoRaWAN Application Command document
and
Netvox Lora Command Resolver
to resolve uplink data.
http://www.netvox.com.cn:8888/page/index
