5
5. Data Report
Data report configuration and sending period are as following:
Min. Interval
(Unit:second)
Max. Interval
(Unit:second)
Reportable Change
Current Change≥
Reportable Change
Current Change
＜
Reportable Change
Any number between
20~65535
Any number between
Min.~65535
Can not be 0.
Report
per Min. Interval
Report
per Max. Interval
The device will immediately send a version packet report along with two uplink packets including 3 current, 3 multiplier and
battery voltage.
The device sends data in the default configuration before any configuration is done.
Default setting:
Maximum time: Max Interval =15 min (900 s)
Minimum time: Min Interval =15 min (900 s)
CurrentChange:0x0064 (100 mA)
*The interval between min time and max time must be the greater than 20 seconds.
Note:
(1)
The device report interval will be programmed based on the default firmware which may vary.
(2)
If MinTime configuration less than 20 seconds, it will configure 20 seconds.
(3)
R718N3 series would take about 3 seconds for the CT to sample and process the collected value. If the current changes
frequently, the sampling result might be wrong.
Please refer Netvox
LoRaWAN Application Command document
and
Netvox Lora Command Resolver
http://loraresolver.netvoxcloud.com:8888/page/index
