9
6.
Installation
1. Tear off the 3M sticker on the back of the
R313CC, and stick the body to a smooth wall.
(Please do not stick it on a rough wall to avoid
the device from falling off after a long time of
use).
Note:
Please wipe the wall clean before installation
to avoid dust on the wall which may affect
the installation of the device.
Do not install the device in a metal shielded
box or in an environment with other
electrical equipment around it to avoid
affecting the wireless transmission of the
device.
2. Tear off the 3M sticker at the bottom of the
reed switch and the magnet (as the red frame
in the figure above).
Then, stick the reed switch and the magnet to
the door or window in parallel (as the figure on
the right).
Note:
The installation distance between the reed
switch and the magnet should be less than
2cm.
3. When the door or window is opened, the reed switch is
separated from the magnet, and the device reports the data
immediately.
4. If it detects that the battery voltage exceeds the
variation during Min Time, the data will be reported
immediately.
5. Whether the state of the reed switch status changes, the
data will be reported regularly when the Max Time.
Note:
When the reed switch is closed, the status is “0”.
When the reed switch is opened, the status is “1”.
R313CC is suitable below scenarios:
Door, window
Drawer
Archives
Closet
Refrigerators and freezers
Cargo ship hatch
The place needs to detect the opening and closing status.
Installation Diagram of R313CC
