13
after you remove the base cable, repeat
the above steps.)
7) scan the last code on page 9 “save &
exit”.
Troubleshooting the scanner
(continued)
The reader does not emit
a beam and read bar
codes.
The reader is
not receiving
power.
Make sure the battery pack is fully
charged. Replace the battery pack if
damaged.
Scanner does not read
bar codes quickly and
sometimes requires
multiple scans.
The battery pack
power is lower than
5V.
Charge it. Full charging needs 3-5 hours
until the light turns into red.
The scanning
window
is
dirty
Clean the window with a cotton cloth
moistened with an ammonia and water
solution. Dry with a soft cotton cloth or
allow to air dry.
The bar code
is dirty.
Make sure the bar code is free of dirt
and grime. Then scan at a slight angle or
pitch to the bar code (see “Operating the
Scanner” earlier in this guide).
You
didn’t
scan
in
appropriate
distance.
Try
adjusting
the
scanning
distance.
Scanner cannot read
certain bar codes.
The scanner was
not set up to read
this type of barcode
symbology, or the
bar
code
is
damaged, covered
up, or of poor
quality.
Scan another bar code on a similar item.
If it scans, clean the bar code giving you
trouble.
If you are still unable to scan, restore the
scanner to original settings. If you still
fail, try using other scanner.
The
scanner
does
not
recognize the
programming
bar
code
Make sure you are scanning the correct
programming bar code and try again.
