NV-202M/S LAN extender with Remote Power
USER’S MANUAL Ver. A.2
24
A.2 Telephone wire
Standard telephone wire of any gauge or type-flat, twisted or quad is used to connect the NV-202M/S to the telephone
network. A telephone cable typically consists of three pairs of wires, one of which is used for transmission. The connector at
the end of the telephone cable is called RJ-11 connector and it consists of eight pins. VDSL signal use pins 4 and 5 for data
transmission. A telephone cable is shown below. (
Figure A-4
)
A
B
Figure A-4: Telephone cable
The A and B connectors on the rear of the NV-202M/S are RJ-11 connectors. These connectors are wired identically. The
RJ-11 connectors have eight positions, two of which are wired. The NV-202M/S uses the center two pins. The pin out
assignment for these connectors is presented below. (
Table A-2
)
Table A-2:
RJ-11 Line connector Pin out Assignments
Pin#
MNEMONIC
FUNCTION
1
NC
Unused
2
DSL
Used
3
DSL
Used
4
NC
Unused
