NS-280FX
: 8x SFP Slots with 2 Giga unmanaged Ethernet switch Ver.A.3
8
Chapter 2.
Installing the Device
2.1 Hardware Installation
This chapter describes how to install the device and establish the network connections. The NS-280FX may be
installed on any level surface (e.g. a table or shelf, 19 inch rack or wall mounting). However, please take note of the
following minimum site requirements before one begin.
4 rubber feet on the bottom has been pre-installed.
2.2 Pre-installation Requirements
Before you start the actual hardware installation, make sure you can provide the right operating environment, including
power requirements, sufficient physical space, and proximity to other network devices that are to be connected.
Verify the following installation requirements:
•
Power requirements:
AC 100-240 volts / 50-60 Hz
•
The device should be located in a cool dry place, with at least
10cm/4in
of space at the front and back for
ventilation.
•
Place NS-280FX away from direct sunlight, heat sources, or areas with a high amount of electromagnetic
interference.
•
Check if the network cables and connectors needed for installation are available.
•
Do not install phone lines strapped together with AC power lines, or telephone office line with voice signal.
•
Avoid installing this device with radio amplifying station nearby or transformer station nearby.
