NetShelter AR1000A, User Manual

Page: 30 / 44

24
Mounting Rails
continued
How to adjust
the mounting
rails
1. Use the 5 mm Allen wrench (included) to loosen (but not
remove) the socket-head screws in the slots of the mounting
rail.
Note : If your enclosure was shipped with equipment
already installed, you will need to remove the socket-
head screws in the round holes of the mounting rails
before adjusting or moving the rails.
2. Slide the mounting rail forward or rearward as desired.
Tighten each screw.
How to move
the rails to a
new position
1. Remove the side panels from the enclosure. (See page 13.)
2. Use the 5 mm Allen wrench (included) to remove the
socket-head screws in the slots of the mounting rail.
3. Locate the new position for the mounting rail.
4. Secure the vertical mounting rail to each horizontal brace:
Note: You may have to adjust the position of the brace up or
down to align it with the mounting channel in the rear
mounting rail. (See “How to move a brace” on page
25.)
a. Insert a caged nut into the appropriate holes at the new
position on the upper brace.
b. Place the mounting rail at the new position and insert a
socket-head screw through the rail, brace, and caged nut.
c. Tighten the screw to secure the mounting rail to the
brace.