Netopia 3342, Software User'S Manual, Page: 243 / 351

243
CONFIG Commands
the raw WAN (DSL) bit rate. The Maximum Burst Size (MBS) is the number of cells that can
be sent at the PCR rate, after which the PVC must fall back to the SCR rate.
set atm [vcc
n
] qos sustained-cell-rate { 1 ...
n
}
If QoS class is set to
vbr
, then specify the
sustained-cell-rate
that should apply to the
specified vir tual circuit. This value should be less than, or equal to the Peak Cell Rate,
which should be less than, or equal to the line rate.
set atm [vcc n ] qos max-burst-size { 1 ... n }
If QoS class is set to vbr then specify the max-burst-size that should apply to the speci-
fied vir tual circuit. This value is the maximum number of cells that can be transmitted at
the Peak Cell Rate after which the ATM VC transmission rate must drop to the Sustained
Cell Rate.
set atm [vcc n ] vpi { 0 ... 255 }
Select the vir tual path identifier (vpi) for VCC n.
Your Ser vice Provider will indicate the required vpi number.
set atm [vcc n ] vci { 0 ... 65535 }
Select the vir tual channel identifier (vci) for VCC n. Your Ser vice Provider will indicate the
required vci number.
set atm [vccn] encap { ppp-vcmux | ppp-llc | ether-llc |
ip-llc | ppoe-vcmux | pppoe-llc }
Select the encapsulation mode for VCC n. The options are:
ppp-vcmux PPP over ATM, VC-muxed
ppp-llc PPP over ATM, LLC-SNAP
ether-llc RFC-1483, bridged Ethernet, LLC-SNAP
ip-llc RFC-1483, routed IP, LLC-SNAP
pppoe-vcmux PPP over Ethernet, VC-muxed
pppoe-llc PPP over Ethernet, LLC-SNAP