Control and configuration
12
Timer mode:
timer mode sets the frequency of timed switch-on/switch-off. The options are: ONCE
the event occurs only once, DAILY the event is repeated everyday or WEEKLY the event
is repeated only on the days selected in the "Week Schedule" field.
ON time:
date and time port switched on, if you select the DAILY mode, this shall be the date and
time of first switch-on
OFF time:
date and time port switched off, if you select the DAILY mode, this shall be the date
and time of first switch-off
Week schedule:
The selection that determines the days of the week on which the
Timer
function is active
if you have selected
WEEKLY
in the
Timer mode
field.
Interrupt delay:
time (in seconds) over which the port shall be off when using the
Interrupt
function in
the manual setting of the port, or when using
Watchdog
function
Watchdog
The
watchdog
function is used to monitor the operation of the device in the network. If the monitored device does
not respond to ping queries within a given interval, the plug for which this function is set is deactivated for a
given period and then reactivated. To restrict continuous switching of the port in case of failure of the monitored
device, it is possible to set the maximum number of restart attempts for a given port.
Enable:
activation of
watchdog function
IP address:
IP address of the network device to be monitored
Timeout:
maximum response time of the monitored device
PON delay:
time interval (in seconds) over which the
Watchdog
function shall not be active after port
restarts. During this period, the monitored device should start operating after restart.
Ping interval:
interval (in seconds) in which queries shall be sent to the device
Max retry:
maximum number of port restart attempts if the monitored device does not respond to the
ping commands. After expiry of the given number of attempts, the port remains inactive.
Retry POFF:
activation of
Max retry function
Send e-mail:
send e-mail information if the monitored device did not respond and was restarted
Click the
Apply
button to save the setting.
5.2. System configuration
Here, the user can set the parameters of the network, e-mail, system time, administer the user accounts and install
new firmware on the device.
5.2.1. Configuration of network parameters
Upon clicking the
Configuration
button, the system configuration page is displayed. Here, you can set the
IP
address
,
Subnet mask
,
Default gateway
and
DNS server
according to your network parameters. If you do not
want to use manual configuration of the network, you can switch the
DHCP
by selecting
Enable
, and the device
automatically sets the parameters according to the
DHCP
server.
Summary of Contents for 230C
Page 1: ......
