NETGEAR WNR2000, Setup Manual

Page: 6 / 48

2 Getting to Know Your Wireless Router
To prepare your router for installation:
1.
Carefully peel off the protective film covering both sides of your router (see Figure 1 ).
2. Set up your wireless router by inserting the tabs of the stand (supplied with your router) into
the slots on the bottom of your router as shown in
Figure 2 . Then, remove the protective film
covering the status light panel of the router.
3. Place your router in a suitable area for installation (near an AC power outlet and accessible to
the Ethernet cables for your wired computers).
Figure 1
Figure 2
To ensure proper heat dissipation and for router stability, it is important that you
connect the stand and place your router in an upright position.