Power LED
The Power LED is located above the Power On/Off button on the rear panel.
The following is the LED behavior for the Power LED:
•
Solid green. Power is on.
•
Solid amber. The satellite is booting.
•
Blinking amber. The satellite is resetting to factory default settings.
•
Blinking red. The firmware is corrupted.
•
Off. Power is not supplied.
Bottom Light LED
You can use the top and bottom Light LEDs to provide light to your outdoor area. You
can also use the bottom Light LED behavior to help you determine the status of your
satellite. The top Light LED only provides light.
The following table describes the bottom Light LED behavior.
Table 1. Bottom Light LED behavior
Bottom Light LED behavior
Color
The satellite is booting.
Pulsing white
The satellite is ready to sync with the Orbi router.
Solid white
The satellite is trying to sync with the Orbi router. The
LED might pulse white for about six minutes.
After the LED pluses white, it lights blue, amber, or
magenta. See the next table for more information.
Pulsing white
(Note that the bottom Light LED pulses white again after
the Sync button is pressed.)
The satellite is warming up because its temperature
is less than 41°F (5°C). This might take about 15
minutes if the surrounding temperature is less than
4°F (–20°C).
Pulsing amber
After the Sync button is pressed, the bottom Light LED pulses white. Then the bottom
Light LED lights one of the following colors for about 3 minutes and then turns off:
User Manual
8
Overview
Orbi Outdoor Satellite
