background image

 Ideal for fringe reception areas

 Tilting mast clamp for easy adjustment

 Easy dipole assembly

 Unique compact folding design

 Frequency: 470 - 790MHz

 Forward Gain: 13dBi

 Length:  680mm

 Electronic 75Ω balun

 Connection: F type

Congratulations on the purchase of your high gain digital aerial. The aerial is ideal for the  

reception of all available signals in medium, weak and fringe areas.  

The aerial has also been designed to restrict bandwidth to prevent interference &  

channel loss on TVs caused by  signals from 4G mobile phone transmitters.
The aerial is of particularly robust construction to ensure a long operating life.

For optimum results install the aerial using double screened CAI approved digital coax cable 

and screened coax outlets. You will need to fit the coax cable with an F type connector to 

connect to the aerial balun.

1.  Prepare the Coax Cable: Firstly fit the rubber weather boot provided, to the  
  aerial end of the cable. Strip the end of the cable as shown in Fig. 1.  
  Once you have stripped the cable, twist the braid and pull it back on itself,  
  make sure that no braid is touching the copper core, this will cause a short  
  on the cable and you will not get any signal.  

2.  Fitting the F connector (not supplied): Now, simply twist on an  
  ‘F’ connector and trim central conductor. 

fold braid back

over sheath

8mm

inner

wire

cut or tear 

away foil 

6.5mm

Fig. 1

screw connector

body onto cable

2mm approx.

end of  

insulation

should be  

flush with 

this face

Fig. 2

For best results the aerial should be mounted on an outdoor aerial mast and 

pointed in the direction of the nearest transmitter* making sure it is in a position 

where the transmitter signal will not be obstructed by nearby trees and buildings.  

If you are in any doubt about the direction in which the aerial should be pointing 

or the orientation of the aerial (horizontal for main transmitter, vertical for relay 

transmitter) check your neighbours’ aerials.

3.  Unfold the booms as shown above. To lock the booms in position turn both of  

  the two knobs on either side of the aerial in a clockwise direction through 180˚  

  making sure that the arrows line up with the locked symbol - see Fig. 4.

4.  Next fasten the balun to the underside of the main central boom as shown in Fig. 5.  

  Make sure the balun is the right way round with the locating stud slotted into the  

  locating hole on the underneath of the central boom.

Fig. 3

Fig. 4

Locking knob

Locked 

Symbol

Installation Instructions

Lte

800

READY

High Gain Professional T Band 

Aerial

LAB350T

USER GUIDE

 

Fig. 5

locating stud

Reviews: