Security Gateway Manual
XG-7100-1U
Warning:
Before proceeding:
1. Backup your configuration file.
2. Unplug the system for at least 60 seconds to ensure all phantom power has dissipated.
3. Anti-static protection must be used throughout this procedure.
4. Any hardware damage incurred during this procedure is
not covered
by the hardware warranty.
The XG-7100 PCIe Installation Kit from Netgate includes the components pictured below.
Fig. 17: Bracket, Screws, Riser, and Extender
When installing an optional expansion card, first install the riser and extender using the riser mounting bracket. The
instructions below are for installing an X710 expansion card, but other expansion cards are installed the same way.
1. Remove the seven (7) lid screws and remove the lid.
Note:
Some systems may only have six (6) lid screws.
2. Remove the faceplate by unscrewing the 4 black faceplate screws.
3. Remove the L-Bracket behind the faceplate blank by unscrewing 1U Lid screw (M3x0.5 6MM Long Flat Head).
Note:
Notice that the L-Bracket is behind the Faceplate Blank, locking it into place.
4. Remove the faceplate blank.
5. Using Long Board Mount Screws, attach the riser card to the mounting bracket.
6. Line up the riser with the connector and insert the riser into the slot.
© Copyright 2020 Rubicon Communications LLC
62
