Security Gateway Manual
XG-7100-1U
7. Push the M.2 SATA drive down until it is parallel with the system board and use the screw to secure the M.2
SATA drive in place.
Fig. 14: Secure the M.2 SATA Drive
8. Turn the board over and place it into the chassis. Secure the system board with four (4) board screws.
9. Replace the power supply connector and fan connectors.
10. Replace the lid and lid screws. Be sure the L-Bracket is not pinched by the lid.
11. Reinstall the pfSense software on the new M.2 SATA drive.
12. Restore your configuration backup if you have one.
2.5 Expansion Card Installation
The XG-7100 1U has a x4 PCIe expansion bus. By default, the expansion card riser and extender are not installed
unless purchased separately with an expansion card.
Note:
Although the PCIe expansion bus is x4, the extender can accommodate x4 or x8 expansion cards.
Some older extenders were x4 only.
© Copyright 2020 Rubicon Communications LLC
59
