Install Hardware
27
3.4. Power Supply Unit
The system compromises up to two power supply units.
TO AVOID SEVERE SYSTEM OVERHEATING, ALL PROCEDURES ON THIS SEC-
TION SHOULD BE PERFORMED WITHIN 10 MINUTES.
3.4.1. Removing a PSU
To remove a PSU, do as follows:
1. Push the PSU handle (A) to the side into the open position.
2. Press and hold the locking latch (B) lever.
To avoid damaging the PSU, support the module whith the second hand when
pulling out of the system.
3. Pull the PSU out of the system.
Figure 3.9. Removing PSU
1
A
B
2
3
3.4.2. Installing a PSU
To install a PSU, do as follows:
To avoid damaging the PSU, support the module whith the second hand when in-
stalling to the system.
1. Insert the PSU into the system. Make sure the PSU is flush with the system and the locking
latch lever (B) is locked in place.
2. Push the PSU handle (A) to the side into the closed position.
Summary of Contents for Aeon J460 M2 JBOD
