4.1.3 Enter the IP Address
Enter the DSLAM's IP address* into the address field at the top of your browser window. Press
the Enter key.
4.1.4 Log In
Log in with your assigned username and password.* Please note that General Users have read
only access; for AAM8000 configuration you must log in as a Superuser.
*If the IP address, username and/or password are unknown, contact your System
Administrator or Information Technology Manager for assistance.
Once you have logged in as a Superuser, you may make configuration changes to the AAM8000, and
any other interface modules installed in the IP DSLAM, as desired. For more detailed information
regarding AAM8000 parameters and configuration, refer to Section 5.0 of this manual and/or the
NMS Management User Guide.
4.2 Via CLI
Interface modules in an IP DSLAM with a Command Line Interface (CLI) compatible MUM (select
models only) can be managed with a Terminal Emulator program (loaded onto your PC) via a set of
commands and sub-commands/qualifiers.
4.2.1 Establish a Connection with the IP DSLAM MUM
Establish a direct connection with the MUM through the RS232 COM Port on the MUM
faceplate.
4.2.2 Launch a Terminal Emulator
Launch a Terminal Emulator program on your PC. Net to Net Technologies copyright
information will appear on your screen followed by a request for username.
4.2.3 Log in
Log in with your assigned username*. Once your username has been entered, a request for
password* will appear. Please note that for AAM8000 configuration you must log in as a
Superuser (General Users have read only access).
*If your username and/or password are unknown, contact your System Administrator or
Information Technology Manager for assistance.
Once you have logged in as a Superuser, you may make configuration changes to the AAM8000, and
any other interface modules installed in the IP DSLAM, as desired. For more detailed information
regarding AAM8000 parameters and configuration, refer to Section 5.0 of this manual and/or the
CLI and SNMP Management User Guide.
210-0000039 rev 07
