Net Optics SpyderSwitch, Installation Manual

Page: 9 / 20

2xN 10/100 In-Line SpyderSwitch
Connecting to the Monitoring Devices
1 .. Supply.power.to.the.SpyderSwitch.using.the.power.supply.included.with.
the.unit ..Verify.that.the.Power.LED.illuminates .
2 .. Connect.2.CAT5.RJ45.straight-through.cables.to.Analyzer.Port.1.A/B.on.
the.front.of.the.SpyderSwitch .
3 .. Connect.the.other.end.of.the.RJ45.straight-through.cables.to.the.appropri-
ate.ports.on.the.monitoring.device .
4. Connect one end of the supplied DB9 cable to the first Serial porton the
rear.of.the.SpyderSwitch .
5 .. Connect.the.other.end.of.the.DB9.cable.to.the.Serial.port.of.your..
monitoring.device .
6 .. Repeat.Steps.2.thru.5.above.to.connect.a.second.monitoring.device.to.the.
SpyderSwitch.using.Analyzer.Port.2.and.DB9.serial.port.2 .
Note: Until the software has been configured, the LED display will
read '00' meaning no port has been selected by the software.
Note: Straight-thru cable is used when connecting the SpyderSwitch to
a Router or NIC. Cross-over cable is used when connecting the
SpyderSwitch to a Network Switch or Hub.