HOW TO PROGRAM ENTRY & EXIT TIMES
Your PRO-L Control Panel will have
zone(s) which are called Entry/Exit
zones. These are the zone(s) which you
normally enter and leave your premises
by. To allow you to do so without
causing a false alarm, there is an Exit
Time which the Control Panel gives you
to depart your premises after you Arm
the Panel. There are 2 separate Entry
Times which the Control Panel gives
you to Disarm the Panel when you have
entered the premises before an alarm
occurs.
Your installer may have programmed
zones with a long entry time and a short
entry time zone. (A long and short entry
time is useful if you enter by a garage
or a front door).
To Program You Must Know a Few
Rules
Exit Time can be programmed from 1 to
99 seconds in 1 second increments.
PRO-L / PRO-LD User Manual
19
Entry 1 time can be programmed from
1 to 99 seconds in 1 second
increments.
Entn; 2 time can be programmed from
10 to 990 seconds in 10 second
increments
Each one of the timers has a 2 digit
program option number.
The current timer value is displayed by
the PRO-L when you select a timer
option. The value is displayed bv
flashing out the value on the numeric
zone lights 1 to 8, 9 = battery and 0 =
Mains at 1 second intervals.
When vou change the timer value the
new value is displayed as above. The
option numbers are as follows:
Entry 1 Timer = option 26
Entry 2 Timer = option 27
Exit Time = option 28
Programming always follows this
sequence;
