26
ness Guardpost installation & Programming
sms
Programming
Many Guardpost programming options can be programmed remotely by SMS message.
Some programming can only be performed locally by radio key.
To program a Guardpost by SMS you must know the mobile phone number of the
Guardpost’s SIM card and the client account number.
SMS programming commands are sent to the Guardpost in this format:
CCCC,PXX=YY,E
CCCC Client account number
4 digits
P
Precedes each program option 01 to 15
Not required for PH1, PH2 & CL1
Must be UPPERCASE
XX
Program option number
01 - 15, PH1, PH2, CL1
YY
Value
E
End of message
Must be UPPERCASE
The Guardpost will reply with a confirmation SMS:
Unit CCCC: PXX=YY, Programmed
If you send an SMS in the wrong format, Guardpost will respond with:
Unit CCCC: Command error.
The SMS format requires a comma between each command and no spaces.
Gsm
sms Programming commands
progrAMMINg by SMS
NOTES
• SMS programming
commands must not include
spaces.
• Some commands must be
sent in uppercase.
• The dialler must be enabled to
allow programming by SMS.
• SMS reply messages are sent
to the mobile phone which
sent the SMS commands
- which can be any mobile
phone.
• IMPORTANT NOTE.
Guardpost may not
respond to SMS commands
immediately if the GSM
module is sleep mode.
The state of the GSM module
is dependent on the power
management mode.
See page 24.
Summary of Contents for Guardpost
Page 36: ......
