
Enter Program mode
Factory Default:
1234
Press the # key 4 times
(Transmit LED will turn off and Program LED will turn red.)
Enter your 4-digit installer code (Default: 1234)
Exit Program mode
Press # at any time to exit programming mode
(or if no buttons are pressed it will exit programming mode)
Selecting keypad transmission format
Note:
Only one
transmission
format can be
used at any one
time.
When Using M1:
Press 1 then
option 4.
Or
Press 1 then
option 5, and you
can have a 5 digit
pin or 4 digits
with # at the end.
Enter Programming mode
Press 1 - (the transmit LED will turn red)
Then you need to select a option from below:
Option
Keypad transmission format
1
Single Key, 6-Bit Wiegand (Rosslare Format)
2
Single Key, 6-Bit Wiegand with Parity Bits
3
Single Key, 8-Bit Wiegand, Nibbles Complemented
4
4 Keys Facility Code, 26-Bit Wiegand
5
1 to 5 Keys + Facility Code, 26-Bit Wiegand
6
6 Keys BCD and Parity Bits, 26-Bit Wiegand
7
Single Key, 3x4 Matrix Keypad
8
1 to 8 Keys BCD, Clock & Data Single Key
After you have made your selection it will then exit programming mode
automatically. - (Transmit LED will turn red)
Examples
If you want to use a 4 digit number as the pin then do the following:
Set the transmission format to option 4 (4 Keys Facility Code, 26-Bit
Wiegand) you would do the following: # # # # 1234 1 4
Or
You may want to enter # at the end of the number then do the following:
Set the transmission format to option 5 (1 to 5 Keys + Facility Code, 26-Bit
Wiegand) you would do the following: # # # # 1234 1 5
Summary of Contents for 101-076
