Apex Wireless Expansion Module (WXM) - Setup Guide
Page 9
ECOSMART AUTOMATIC FIRMWARE UPDATE
Follow these steps to update the EcoSmart firmware using the automatic update method.
Pumps that are configured on the WXM can be updated using this method. The update
procedure is initiated and controlled at the Apex Display, these procedures cannot be
performed from the Apex Web Interface.
NOTE: Automatic update will only update an EcoSmart’s firmware, it cannot downgrade
firmware. If it is necessary to downgrade firmware, follow the steps in the section titled
EcoSmart Manual Firmware Update.
WARNING: Place the WXM and EcoSmart within 2 feet of each other to ensure reliable
wireless communications during the entire firmware update procedure. Make sure all
EcoTech pumps are powered OFF except the pump being updated. Wireless
communications from other EcoTech Marine pumps can interfere with the update process.
Apex Display: Setup – Module Setup – Config Module
1)
If you have more than one WXM connected to the Apex, use the up and
down arrows to highlight the WXM where the pump is connected and press
Select.
NOTE: Only the configured/attached pumps being updated should be
powered on during the update procedure. Wireless communications from
other unattached/unconfigured EcoTech Marine pumps can interfere with
the update process.
2)
Use the up and down arrow keys to highlight EcoSmart Update and press
Select.
The Apex Display will indicate:
EcoSmart Update
Download: XX%
3)
Once the download has completed, the Apex Display will indicate:
EcoSmart Update
Download Complete
Begin Pump
Firmware update
Pumps Updated: X
