Apex Wireless Expansion Module (WXM) - Setup Guide
Page 6
NOTE: To downgrade EcoSmart pumps, the Automatic mode cannot be used, the manual
method must be used in this case.
WWD FIRMWARE UPDATE
Follow these steps to update the WWD firmware. The update procedure is initiated and
controlled at the Apex Display, these procedures cannot be performed from the Apex Web
Interface.
WARNING: Place the WXM and WWD within 2 feet of each other to ensure reliable
wireless communications during the entire firmware update procedure. Make sure all
EcoTech pumps are powered OFF except the pump being updated. Wireless
communications from other EcoTech Marine pumps can interfere with the update process.
Apex Display: Setup – Module Setup – Config Module
1)
If you have more than one WXM connected to the Apex, use the up and
down arrows to highlight the WXM that is within 2 feet of the pump to be
updated and press Select.
2)
Use the up and down arrow keys to highlight WWD Update and press
Select.
The Apex Display will indicate:
WWD Update
Download: XX%
3)
Once the download has completed, the Apex Display will indicate:
WWD Update
Download Complete
Begin Pump
Firmware update
Pumps Updated: X
4)
Remove power to all EcoTech Marine wireless pumps (both WWD and
EcoSmart pumps).
5)
On the pump you wish to update, press and hold the Set and Mode buttons
while you apply power to the WWD pump. Continue to hold these buttons
(about 10 seconds) until the WWD LED flashes red/white. Release the
buttons.
