Neptune R450 MC, Installation And Maintenance Manual

Page: 46 / 104

Installation of the R450 MC
32 R450 Mini Collector Installation and Maintenance Guide
Swiping the MIU
To verify that the R450 MC can receive readings from MIUs and can
synchronize with the N_SIGHT R450 host software, complete the
following steps.
1 Wait about five minutes after you have powered on the R450 MC.
2 With an R450 MIU, position the Neptune magnet against the left
side of the MIU directly in line with the Neptune logo, as shown
in Figure 47.
3 Swipe the MIU bringing the magnet from the side and around the
corner to the top. See Figure 47.
4 When swiped, an email will be sent to the email address that is set
up in the host software. See the example in.
Figure 47 Swiping the MIU
Figure 48 Email Sent from R450 MC
• Make sure the email comes from the R450 MC that you are
installing.
• If you do not receive an email, continue to the instructions out-
lined in "If No Email is Received".
If No Email is Received
If you do not receive an email, do the following:
• Check to see if the lights on the radio module are illuminated.
• If the light is not flashing, call Neptune Customer Support.
Refer to “Contacting Customer Support” on page 52.
• If the radio module lights are illuminated and you do not
receive readings, there is either a problem with the network
connection or a problem with the N_SIGHT R450 host
software.
• Check that N_SIGHT R450 host software is configured to send
emails to the correct email address.
• Check the host software to ensure that R450 MC is synchronizing.
Before you can proceed with these steps, the R450 MC must
be set up in the N_SIGHT R450 host software version 1.6 or
later. See the
N_SIGHT™ R450 Online Help for instructions
for setting up the R450 MC in the host software.
Swipe
Face
plate
Magnet