Neptune R450 MC, Installation And Maintenance Manual

Page: 34 / 104

Installation of the R450 MC
20 R450 Mini Collector Installation and Maintenance Guide
Wiring the Battery Box
Solar-Powered System
Connect the R450 MC to the battery box by completing the following
steps.
1 Attach the 1/2-inch connector hub to the back of the battery box.
See Figure 22.
Figure 22 Feeding Conductor Wire
2 Insert the DC power cable through the connector hub. Insert enough
cable so that it can be terminated to the load terminals inside the
battery box. See Figure 22.
3 Tighten the connector hub using a crescent wrench to secure the
cable. See Figure 23.
Figure 23 Tightening Connector Hub
4 Strip back the insulation 1/2-inch on red and black wires.
5 Attach the red (+) wire to the Load (+) terminal inside the battery
box.
The following instructions are for wiring the battery box
needed for the solar panel of an R450 MC solar-powered
system. If you are installing an AC-powered system, skip this
step.
Connector
hub
Crescent
wrench
Connector
hub
Wire feed from
solar panel Wire feed to
R450 MC