12
BUTTON
BLOWER / PUMP
Blower turns on
Blower turns off
Blower speed decreases. Release pressure
at the desired speed.
Blower speed increases. Release pressure
at the desired speed.
Whirlpool wave cycle begins.
Whirlpool fast wave cycle begins.
Pump starts
Pump stops
ACTION
1
st
Quick Touch
2
nd
Quick Touch
1
st
Touch and hold
2
nd
Touch and hold
1
st
Touch and hold,
until LED goes off.
2
nd
Touch and hold,
until LED goes off.
1
st
Touch
2
nd
Touch
DISPLAY
LED: ON
LED: OFF
LED: ON, while button is pressed.
LED: ON, while button is pressed.
LED: ON until pulsation cycle initiates.
ON again after button is released.
LED: ON until fast pulsation cycle initiates.
FLASHES after button is released.
LED: ON
LED: ON
LED: FLASHES until drying cycle has executed.
COMBO CONTROL
WHIRLPOOL: ADJUSTABLE JETS
Neptune whirlpool jets have two adjustable features, direction
and flow. Direction is adjusted by simply moving the nozzle to
point in the desired direction. Flow is adjusted by rotating the
nozzle
(see fig. 30)
or the face plate for the Maxima jet.
Turning the nozzle or face plate clockwise reduces flow and turn-
ing it counter-clockwise increases it.
WHIRLPOOL: AIR INDUCTION
Neptune’s whirlpool system increases the massaging effect
by drawing air into the jets. The amount of air that is drawn in is
controlled by the air induction valves
(usually one per side, see
fig. 31)
. Turning the valve anti-clockwise opens it allowing more
air to be drawn into the system, turning it counterclockwise
reduces the effect. Air induction greatly increases the foaming
effect of bath foams so care should be taken not to use too much
when operating the whirlpool with the air valves open.
BACK-JETS: DIVERTER VALVE
Some Neptune baths that have the back-jet option are equipped
with an optional diverter valve. This valve
(see fig. 32)
, redirects
flow from the main jets to the back-jets allowing you to balance
the massage to the point where you enjoy it the most.
Turbo
Maxima
Fig. 30
Diverter valve
Fig. 31
Air induction valve
Fig. 32
(option)
A 1-minute drying cycle will automatically be activated 20 minutes after the blower is stopped.
