10
FIXED HEIGHT SKIRTS
The bath must be installed at a specific height in order for the
skirt to fit properly refer to table 1 on page 4 to find the
correct height for your bath.
The skirt is comprised of 3 components, 2 blocks marked “left”
and “right” and the skirt itself
(see fig. 22)
.
•
Step 1:
Install the two blocks marked “left” and “right”,
they must be flush with the lip of the bath and vertically level
(see fig.23)
.
•
Step 2:
Set the skirt in place by pushing it up and behind the
lip of the bath. If you installed the bath at the correct height it
will be a snug fit between the floor and the bottom of the bath
lip. Attach it to the two side blocks using screws through the
holes in the skirt
(see fig. 24)
.
•
Step 3:
Install the caps on the screws.
ADJUSTABLE HEIGHT SKIRTS
The skirt is comprised of 4 components, the L shaped bracket
that screws to the floor, 2 blocks marked “left” and “right” and the
apron
(see fig. 25)
.
•
Step 1:
Install the two blocks marked “left” and “right”, they must
be flush with the lip of the bath and vertically level
(see fig.26)
.
•
Step 2:
Position the L-shaped base 22mm (7/8”) from the front of
the blocs as shown
in fig. 27
and fasten it to the floor with screws.
•
Step 3:
(2 people are required for this operation)
Lift
the skirt into place, flush under the lip of the bath. Attach it
to the two side blocks using screws through the holes in the
skirt
(see fig. 28).
•
Step 4:
Make sure that the skirt is level at the center of the bath
and that it tucks behind the lip. Screw the apron to the base
through the hole in the center of the apron
(see fig. 29)
.
•
Step 5:
Install the caps on the screws.
Flush
22mm
7/8"
22mm
7/8"
Flush
Flush
Centrered
Left
Right
Apron
Base L
Fig. 23
Fig. 24
Fig. 25
Fig. 26
Fig. 27
Fig. 28
Right
Left
Skirt
Fig. 22
Fig. 29
