D I R E C T C O N N E C T 4 H E A V Y D U T Y - V E R S I O N 1 . 0
M A R C H , 2 0 0 4
4
Copyright 2004 - Neptune Systems
All rights reserved
If Switch 1 = On, Switch 2 = Off, Switch 3 = On, and Switch 4 = Off then the DC4 will respond to
commands sent to addresses B5 through B8. The AquaController must be configured to use the
same addresses as selected on the DC4. Refer to the AquaController Owner’s manual for more
information on how to set up the AquaController.
X-10 Input (X-10 In)
The left RJ-11 connector (telephone plug) is the input connector for the X10 signal. A telephone style
cable (supplied with the DC4HD is used to connect this DC4HD X-10 port to the AquaController.
The length of this cable should be less than 10 feet.
X-10 Output (X-10 Out)
The right RJ-11 connector (telephone plug) is the output connector for the X10 signal. A telephone
style cable (4 internal wires) should be used to connect this X-10 output port to another DC4HD X-
10 input port. Always connect X-10 inputs to X-10 outputs when daisy chaining multiple DC4s
together. The last DC4HD in the chain should either have its X-10 output unconnected or connected
to an X10 power-line interface. The total length of all X-10 cables should be less than 20 feet.
Internal Fuse
Inside the DC4HD there is a fast-blow 15-amp fuse. In the event of an overload or short circuit this
internal fuse will blow.
Only replace with a 15-amp or smaller fuse
. Replacement fuses may be
purchased directly from Neptune Systems.
Always disconnect all power before opening the
DC4HD case, and never apply power when the DC4 case is open.
Neptune Systems Limited Warranty
Neptune Systems warrants this product to be free from defects in material and workmanship for a
period of 1 year from the date of purchase. If repair or adjustment is necessary and has not been the
result of abuse, misuse, or accidental damage, within the 1-year period, please return the product with
proof of purchase, and correction of the defect will be made without charge.
For your protection, items being returned must be carefully packed to prevent damage in shipment
and insured against possible damage or loss. Neptune Systems will not be responsible for damage
resulting from careless or insufficient packaging. Before returning please obtain a return authorization
(RMA) number from Neptune Systems at (408) 578-3022. Returned merchandise will not be
accepted without a RMA number.
Except for the warranty set forth above, Neptune Systems is not responsible for any damages
including, but not limited to, consequential damage occurring out of or in connection with the
delivery, use or performance of Neptune Systems’ products. Buyer’s remedies for breach of warranty
shall be limited to repair, or replacement and full or partial adjustment to purchase price.
