Apex Classic Setup and Programming Guide v2.2
Page
26
dropdown list, click the Rename radio button, click the Submit Module
Update button.
CONFIGURE AN APEX MODULE
Some AquaBus modules have configuration settings that can be updated through
the Config Modules menu found from the Apex Display at Setup – Module Setup –
Config Module. The Apex Wireless Expansion Module (WXM) is the first of these
modules. If you have a WXM, please see the instructions that came with the WXM
for setup instructions. If you do not have a WXM, this menu item will do nothing,
this is normal.
LEGACY MODULE SETUP
All legacy modules except the PX-1000 must be manually added to the Apex
system configuration. Once added to the system, they are
configured/programmed just like any other port or outlet on the Apex system.
The following legacy modules are supported:
Direct Connect 4 – Provides control of four 120V AC outlets
Direct Connect 4 HD – Provides control of four heavy duty 120V AC outlets
Direct Connect 8 – Provides control of eight 120V AC outlets
Lunar Simulator – provides lunar cycle control of LED lights
AquaSurf – provides variable voltage control ports for variable speed Tunze
Streams pumps
You need to assign all legacy modules (except the PX-1000) a unique address
before adding to the Apex system. See the section titled Connecting Legacy
Modules for instructions on connecting the Legacy Modules to the Apex system.
Finally, the Legacy Modules must be manually added to the Apex system
configuration by following the directions in the section titled Adding Legacy
Modules to the Apex System. After the legacy modules have been added to the
system, they are configured and programmed like all other Apex ports and
outlets.
ADDRESSING LEGACY MODULES
The address needs to be unique to all other legacy modules on the system. You
do not need to worry about Apex module addresses as they are automatically
assigned on the AquaBus and will not conflict with legacy addresses. Once the
