Neptun Classic NCTP-O 300i, Operating Instructions Manual

Page: 11 / 96

- GB -
- GB -
11
Intended use
NCTP-O 300i, referred to as "unit", may only be used as specified in the following:

For operation with clean water.

Operate in accordance with instructions.
The following restrictions apply to the unit:

Do not use in swimming ponds.

Never use the unit with fluids other than water.

Never run the unit without water.

Do not use for commercial or industrial purposes.

Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.

Do not connect to the domestic water supply.
Installation and connection
WARNING
Death or serious injuries from hazardous electrical voltage due to operation of this unit in a swimming pond.

Never operate this unit in a swimming pond.
How to proceed:

B
1. Set the flow rate:
– Turning the socket clockwise: Increases the flow rate.
– Turning the socket counterclockwise: Decreases the flow rate.
2. Fit the hose onto the outlet.

C
3. Install the pump fully submerged.
– Ensure that the maximum permissible submersion depth of 1 m is not exceeded
– Route the power cable so that it forms a loop below the power socket.
Commissioning/start-up
NOTE
Never allow the pump to run dry. Otherwise the pump will be destroyed.

Ensure that the pump is always flooded during operation.

Regularly check the water level.

Switching on: Insert the power plug into the socket.
– The unit switches on immediately.

Switching off: Disconnect the power plug.