POC-100 User’s Manual
Copyright © 2013 Neousys Technology Inc. All Right Reserved.
Page 54 of 65
SATA Only mode.
If you’re using Windows Vista, Windows 7, Windows 8, or Linux kernel from 2.6.19
onward, you can select AHCI mode for better performance.
To set SATA controller mode:
1. When POC-100 boots up, press F2 to enter BIOS setup utility.
2. Go to [Advanced]
[SATA Configuration].
3. Set the [HDC Configure as] to a proper mode for your POC-100.
IGD Boot Type & LVDS Output Resolution
POC-100 has an Integrated Intel® GMA 3150 graphics engine in its Atom D525 processor.
The Integrated Graphics Device (IGD) supports VGA and LVDS dual independent outputs.
By default, POC-100 is configured as VGA output only. If you connect POC-100 to a LCD
panel via its internal LVDS connector, you should enable the LVDS output and configure the
LVDS output resolution according to your LCD panel.
To set the IGD Boot Type:
1. When POC-100 boots up, press F2 to enter BIOS setup utility.
2. Go to [Advanced]
[Video Configuration].
3. Set the [IGD Boot Type] to a proper value for your POC-100.
Select “VGA” to enable VGA output only
Select “VGA+LVDS” to enable VGA and LVDS output