IGT-30 Series
41
6. Initial Login
There are two ways to log into the system and setup your IGT-30. Method one is to
login by connecting to the console port of IGT-30 and the host computer, and method
two is to connect a host computer to the Ethernet port of IGT-30 and access via a
SSH-supported terminal application such as PuTTY.
6.1
Login via Console Port
Establish a connection between your host computer and IGT-30’s console port
(connector 1, pins CTX, CRX and GND). Please note that a cross-over cable is
required (CTx to Rx and CRx to Tx) and you must connect to
1.
Right click on
, click on “Run as administrator” to bring up the
PuTTY Configuration window.
2.
Go to Category > Serial, enter the COM port you connected your host computer
to IGT-30 and enter the following parameters: