Neopost IM-75, User Manual

Page: 16 / 24

15
ENGLIS
H
5. FAULT FINDING
The fault codes are shown at the bottom
of the display as follows (see figure
below):
• Position 1: fault in area before slitting
unit 1 (see “General” on page 7): e.g.
envelope stoppage or feed hopper
empty.
• Position 2: fault in area beyond slitting
unit 1: e.g. envelope stoppage or
envelope fails to arrive.
• Position 3: fault on the conveyor belt:
e.g. envelope stoppage or envelope fails
to arrive.
• Position 4: fault at the removal station:
e.g. envelope fails to arrive.
• Motor blocked: slitting unit 1 or 2 is
blocked. All motors are immediately
switched off. Remove obstruction from
slitting blade 1 or 2.
• Motor blocked: the cover is not correctly
closed. Check cover.
• Too slow: the envelope has left the
hopper but it takes too much time to
arrive at position 1. Press the “Auto” (D)
or “Opto” (C) to continue.
Note: When the last envelope has been
removed from the envelope feed hopper,
the suction arm continues to try to extract
an envelope from the stack at each cycle.
The display then shows: position 1 and
then 2-3-4.
Note: If at start-up the fault code position
1, 2, 3 or 4 shows up and there is no
envelope at this position, clean the
photocell. Use a dry cloth or compressed
air to clean the photocell.
Once the last envelope has passed
through the removal area, no further
cycles can be triggered. New envelopes
must now be placed in the envelope feed
hopper to continue.
If an envelope is removed from any of the
areas by hand, the next envelope is
automatically moved forward to replace it.
1 2
3 4