Neopost IM-75, User Manual

Page: 14 / 24

13
ENGLIS
H
4.10 Suction air regulation
At the extraction point, if the contents are
stuck to the top or bottom of the
envelope, it is possible to reduce the
suction of each suction arm. The setting
buttons A and B (see figure below) are
positioned at the envelope feeder.
A : Setting button top suction arm
B : Setting button bottom suction arm
• If the contents are stuck to the top or
bottom of the envelope, the top or
bottom suction setting can be reduced
by turning the control clockwise.
• If the envelope is not held securely by
the top or bottom sucker then increase
the suction slightly by turning the
appropriate control anti clockwise.
If there is not enough vacuum available
replace the filters (see “Replace filters” on
page 16).
4.11 Adjust envelope shape at
removal area
Use the eccentric I (see “Operating
controls” on page 7) to adjust the
envelope shape when opening at the
removal area.
4.12 Electronic Document
Detector (optional)
4.12.1 Setting up the Electronic
Document Detector
To setup the Electronic Document
Detector proceed as follows:
• switch on the power switch.
• press the standby button H to switch off
the transportation belts.
• press the setting button L.
• turn the control knob K to position (0).
• place an empty envelope under the
sensor (beyond the removal station).
The indicator lamp J lights up.
• turn the control knob clockwise until the
indicator lamp goes out.
• turn the control knob one position
further (e.g. from 2 to 3).
• use the locking device to fix the control
knob in this position.
• press the operating button M (the led in
the button lights up).
• press the “Auto” (D) or “Opto” (C)
button to switch on the transportation
belts (see “Control panel” on page 9).
• the detector is now ready to operate.
Buttons M and L have both been
pressed, both led are illuminated.
+
-
+
-
A B
F G H J
L M N
K
I